Silicon-image SiliconDrive SSD-H16G(I)-3500 User Manual download pdf (Page 16)

ELECTRICAL SPECIFICATION SSD-HXXX(I)-3500 DATA SHEET

SILICONSYSTEMS PROPRIETARY

This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.

All unauthorized use and/or reproduction is prohibited.

3500H-03DSR PAGE 7FEBRUARY 2, 2009

SIGNAL DESCRIPTIONS

Table 9: Signal Descriptions

Signal Name Pin(s) Type Description

A2-A0 36, 33,

I Address Inputs. These signals are

asserted by the host to access the task

registers in the device.

-CS0,-CS1 37, 38 I In the true IDE mode, -CS0 is the chip

select for the task file registers while -CS1

is used to select the Alternate Status

-CSEL 28 I Cable Select. This internally pulled-up

signal is used to configure this device as a

master or a slave when the jumper

configuration is in CSEL mode.

When this pin is:

• Grounded by the host, this device is

configured as a master.

• Open, this device is configured as a

slave.

D15-D0 18, 16,

14, 12,

10, 8, 6,

4, 3, 5, 7,

9, 11, 13,

15, 17

I/O Data Inputs/Outputs. This is the 8-bit or

16-bit bidirectional interface between the

host and device. The lower eight bits are

used for 8-bit register transfers.

-DMACK 29 I DMA Acknowledge. This signal is used by

the host in response to DMARQ to initiate

DMA transfers. The DMARQ/-DMACK

handshake is used to provide flow control

during the transfer. When -DMACK is

asserted, -CS0 and -CS1 are not asserted

and transfers are 16-bits wide.

DASP 39 I/O Disk Active/Slave Present. This open

drain output signal is asserted low any time

the drive is active. In a master/slave

configuration, this signal is used by the

slave to inform the master that a slave is

present.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Comments to this Manuals

No comments

Silicon-image SiliconDrive SSD-H16G(I)-3500 User Manual Page 16

Comments to this Manuals

Related products and manuals for Hardware Silicon-image SiliconDrive SSD-H16G(I)-3500